JVC MC-R433U Manuel D'instructions page 4

Procedure for Installing the MC-R433U in
the CD/DVD Library
Sensor slit
<MC-R433U insertion direction>
MC-R433U
<MC-R433U locking method>
1.
Insert the MC-R433U from the rear of the CD/DVD Library
Be sure not to damage the sensor slit.
Make sure that the direction of the MC-R433U is correct
when inserting it.
Be sure that the cables connected to the rear of the CD/
DVD Library are not caught or pinched when inserting
the MC-R433U.
2.
Insert the MC-R433U slowly until the screw installation hole
located on the side of the MC-R433U and the screw instal-
lation hole located on the drive locking section are aligned.
3.
Screw in the provided drive locking screw to the screw in-
stallation hole of the drive locking section.
Tighten the screw firmly.
If the drive locking screw is loose, the drive and/or Li-
brary may be damaged.
E
MC-R433U(E).pm6
All manuals and user guides at all-guides.com
MC-R433U
Drive locking
screw
4
CONNECTION
●
Connect the MC-R433U to the CD/DVD Library.
When necessary, two or more SCSI bus channels
may be used by adding the provided SCSI cable.
If the DVD-R is recorded intermittently due to an in-
sufficiency in the recording transfer rate on the SCSI
bus, the recording quality may deteriorate and play-
back malfunctions may occur.
Also refer to the instruction manual for the CD/
DVD Library.
Procedure for Attaching the Provided
SCSI Cable
* If the provided SCSI cable is not used, go to "Procedure for Con-
necting the Cables to the Back of the MC-R433U" on the next
page.
Blind plate
Connector cap
Drive storage cover
<Provided SCSI cable connection method>
1.
In order to remove the two blind plates, remove the four
screws from the SCSI connector installation section at the
rear of the CD/DVD Library (drive storage cover).
2.
Insert the provided SCSI cable through the installation hole
from the inside of the drive storage cover and secure it with
the four screws.
Remove the connector cap of the SCSI cable for instal-
lation.
Be sure that the SCSI connector is inserted in the cor-
rect direction. (It should be the same as the direction of
the SCSI connector "SCSI-A.")
3.
If the cable or the terminator are not being connected to
the OUT side of the SCSI connector ("SCSI-D"), place the
connector cap over it.
03.7.10, 2:12 PM
Provided SCSI cable
SCSI connector
mounting screw