Eneo EKR-8/4 Manuel D'instructions page 29

[ALARM 1 ACKNOWLEDGE
[----------------------------]
[ 1.Output 1: YES
[ 2.Output 2: NO
[ 3.Output 3: YES
[ 4.Output 4: YES
[
[
[INC.Next Alarm
[DEC.Previous Alarm
[
[SEQ.End
[READ THIS CAREFULLY
[----------------------------]
[ If a new password is
[ inserted and forgotten
[ this setup procedure
[ will be unaccessible
[ and the system locked.
[
[
[ Procede to change pwd?
[ ENTER.Yes
[ CLEAR.No
[VIDEO MASK
[----------------------------]
[
[ Camera no.1
[
[
[
[
[INC/DEC.Camera Change
[ENTER.Show/Change
[
[SEQ.End
[ **********
[ **********
[ **********
[ **********
[ **##******
[ **##******
[
[ CAMERA 1 ]
[ ---------]
[ 1←→2 3↕4 ]
[ Enter ◄ ►]
[ SEQ. End ]
All manuals and user guides at all-guides.com
5.5]
Alarm acknowledge submenu
]
It is possible for each alarm to be recognised by each output video (or not). If
]
an alarm is not recognised the functioning of an output will be unchanged by
]
alarm activation, even if keyboard MTC-1 (when connected) will display a
]
] warning message for the abnormal situation.
]
Press .. to enable/disable alarm acknowledge for each output.
 
]
]
]
Press / to pass to definition of the next/previous alarm. Press
 
]
return to the previous menu.
6.1]
Change password submenu
]
Entering the change setup password submenu will show a warning message
]
on the screen, shown on the screen to the left. Be very careful because if a
]
password setting is lost it will be necessary to contact the supplier to reset the
]
] whole system and all the data will be lost.
]
]
The instructions for changing the password are shown on the screen.
]
]
]
7]
Masking submenu
]
Masking is a system for hiding part of the image when this comes from fixed
]
cameras. If part of the image supplied by the camera is to be covered it should
]
be masked.
]
]
Choose the camera to be masked using
]
preset mask and modify it if necessary. A typical screen is shown in the
]
following example.
]
]
]
]
Submenu for Masking: modify
]
]
The example on the left * shows the current mask for camera 1, # indicates the
]
]
cursor, which can be shifted using the left
]
keys, or by moving the joystick if the matrix is controlled by a MTC-1 keyboard.
]
Press to mask /remove the mask under the cursor.

Pressing the key twice quickly will completely remove the mask on the

video signal.
Press and to select another input video.
 
confirms the changes made to the masks of the various input videos.

Pag. 27
and . Press to view the
  
right up, down
, , 
MNNAEKR_0408
to

