Publicité
Les langues disponibles
Les langues disponibles
[CHANGE TIME
[----------------------------]
[ Actual time: 14:21:25
[ 1.Hour
: 14
[ 2.Minute: 21
[ 3.Zero seconds
[ 4.Format
: 24 HOURS
[ 5.Visible : YES
[ 6.Position: UP/LEFT
[
[
[SEQ.End
[DAY SEQUENCES
[----------------------------]
[
[ 1.Start: O7:OO
[ 2.End
: 17:59
[
[
[
[
[
[
[SEQ.End
[WEEK DAYS
[----------------------------]
[ 1.Monday
: WORKING DAY
[ 2.Tuesday
: WORKING DAY
[ 3.Wednesday: WORKING DAY
[ 4.Thursday : WORKING DAY
[ 5.Friday
: WORKING DAY
[ 6.Saturday : WORKING DAY
[ 7.Sunday
: HOLIDAY
[
[
[SEQ.End
[EXTERNAL TRIGGERS
[----------------------------]
[ 1.Alarm Ext.Reset: NEG _
[
[ 3.Use VCR:
YES
[ 4.Trigger VCR: POS ^
[
[
[
[
[
[SEQ.End
All manuals and user guides at all-guides.com
2.2]
Set time submenu
]
The current time is suggested; pressing
]
minutes respectively. After requesting the change of one of these parameters,
]
]
/
will change its value,
]
sets the seconds to zero.
]
]
]
The hour format can be standard (24H) or twelve-hour (12H).
]
]
Visibility and position can be changed by pressing
Press
to return to the previous menu.
2.4]
Daytime sequence submenu
]
If different day- and night-time sequences are to be used, this menu is used to
]
define the starting time for the daytime sequence on working days. The night-
]
time sequence will be used for the rest of the day and on holidays. (See
]
]
section 4.1.2)
]
]
Press
and
to proceed with the time change.
]
]
the value,
will confirm the change. The minutes can be changed in 10-
]
minute steps. In the example shown on the left, the daytime sequence is used
on working days from 7:00 to 17:59. The night-time sequence will therefore be
used from 18:00 to 06:59.
2.5]
Days of the week submenu
]
If different daytime and night-time sequences are to be used, this menu is used
]
to define the status of each day of the week: for the days defined as WEEK
]
DAYS the night-time sequences are used for the whole 24 hour period. For
]
]
WORKING DAYS both daytime and night-time sequences are used, following
]
the timetable defined in the Daytime sequence submenu.
]
]
]
]
2.6]
External Trigger Submenu
]
Pressing
defines the type of external reset impulse for the alarm condition.
]
If this impulse is not used the value of the setting is not important.
]
]
Pressing
enables/disables recognition of the trigger from the VCR.
]
Pressing
defines the type of VCR's trigger.
]
]
]
For both types of impulse, POS means that the signal is usually low and the
]
]
impulse is recognised on the rising edge; NEG means the signal is usually high
and the impulse is recognised on the falling edge. See the instruction manual
of the device supplying the control impulse for information on the type of signal
to consider.
Pag. 24
and
will change the hour and
will confirm the change.
and
and
.
will change
MNNAEKR_0408
Publicité
