Salora DAB3010FM Mode D'emploi page 7

• If the batteries are replaced while the power is on, the unit may revert to the
factory setting.
• Due to the short battery life span of some alkaline batteries. It is
recommended to use rechargeable batteries. You will need
charger to charge the rechargeable batteries. This saves money
environmentally friendly.
Switching On Your Unit for the First Time
1. After connecting the unit to the power source, Switch the
the unit. The LCD display will show Welcome to Digital Radio, and then the unit will
enter STANDBY mode. Press the /MODE button again, and the unit will automatically
enter DAB mode. The LCD display will show Autotune Full scan, and then the unit will
start scanning.
2. During scanning, the display will show a slide bar that indicates the progress of the
scan, and the amount of radio stations that have been found so far. Once the scan has
• The name of the found group of DAB radio stations will be displayed in the
bottom half of the display.
• The clock will be updated automatically if you can receive DAB signal in your
location. In order to synchronise to the current local time, you must leave it on
the DAB station for a period of time.
• The LCD display shows the time in STANDBY mode.
Basic Operation
Powering ON/OFF
After connecting the unit to the power source:
• Switch
the /MODE button again to switch the unit to DAB/FM mode.
• While the unit is in DAB/FM mode, press and hold the /MODE button. The LCD display
will go to STANDBY.
• Disconnect the power cable of the mains adapter from the mains socket if you want to
Selecting Modes
Press the /MODE Button repeatedly to switch between modes (DAB or FM).
Adjusting Volume
Turn the Press +/- to increase/decrease the volume.
button to switch on the unit, and it will enter STANDBY mode. Press
to purchase a
and is more
button to switch on