Publicité
Liens rapides
This Brizo
end valve assembly has been set up for a cold side installation for a lever handle. If you need to use it for a hot side application,
®
please follow the following steps. Note: This end valve assembly meets the requirements of AB1953.
1
3
1
2
Note the position of the stop lug (1) in
relation to the inlet tube (2). Unscrew bonnet
nut (3) using a wrench.
1/8/09
2
180°
5
4
6
6
Carefully pull up on the stem unit (4) so that the
tabs (5) on the side disengage from the slots (6)
in the body and rotate the stem unit 180°. Push
stem unit back into body and reassemble bonnet
nut securely with wrench.
1
RP54856 End Valve - Hot Side Conversion
3
5
HOT
1
Note: For lever handle model, the inlet tubes
(1) on the end valve assemblies should be
positioned facing out, away from the spout.
Please follow the installation instructions from your
faucet when installing or reinstalling your end valve
assemblies. If you need help, call our Customer
Service Department at 1-877-345-2749.
COLD
1
60731 Rev. A
Publicité
Manuels Connexes pour Brizo RP54856
Sommaire des Matières pour Brizo RP54856
- Page 1 RP54856 End Valve - Hot Side Conversion This Brizo end valve assembly has been set up for a cold side installation for a lever handle. If you need to use it for a hot side application, ® please follow the following steps. Note: This end valve assembly meets the requirements of AB1953.
- Page 2 Departamento de Servicio al Consumidor al 1-877-345-2749. Soupape RP54856 – conversion pour montage du côté eau chaude Cette soupape Brizo est configurée pour être installée du côté eau froide avec une manette. Si vous voulez l’utiliser du côté eau chaude, ®...