Publicité
Les langues disponibles
Les langues disponibles
• Add the selected cutting disc (6) by
locating the 2 tabs (21) on the disc (6)
in the 2 slots in the Mincer body (22)
and the central hole over the boss on
the screw (8) (Fig. F).
• Screw the Mincer fastening dial (5) onto
the body to lock the parts in place.
• Place the Mincer body over the drive
coupling. Push the lock pin back &
rotate the body anti-clockwise. Once
the sprung-loaded pin aligns with the
recess in the Mincer body, the spring
will force it forward to lock the body in
place (Fig. G, H).
• Fit the Mincing tray (10) into the inlet
chute, aligning the rib in the chute with
the slot in the tray (Fig. I).
• Add ingredients to the tray.
• Connect the unit to a suitable supply.
The lamp around the power control will
flash.
• The ingredients can be guided into the
chute with the food pusher (11).
• The chute will guide the ingredients
onto the cutting disc where the blade
will cut it, allowing the cut pieces to be
forced through the holes in the disc.
• Once mincing is completed, return the
power control to the "OFF" position
and disconnect the appliance from the
electrical supply.
• Press the Mincer lock button (20)
release the Mincer body allowing it to
be rotated clockwise & lifted from the
unit.
Warning! Do not operate the mincer for
more than 6 minutes continuously at a time.
Warning! Keep hands, long hair and loose
clothing away from moving parts.
All manuals and user guides at all-guides.com
(Original instructions)
Using the mixer (Fig. J, K, L)
• Clean the beaters, dough hooks, whisk
• Place the appliance on a flat, steady
• Ensure that the power cord is
• Make sure the Blender cover is locked
• Place the bowl (2) in the recess in the
• Press the pivot release button (3) &
• Lifting the housing will release the
• Push the whisk (13), dough hook (14) or
• Beaters are for mixing egg white or
• Add the ingredients to the bowl.
• Press the pivot release button (3) and
and bowl before use.
surface.
unplugged from the power outlet and
the speed selector (4) is set to the "0"
position.
in place. When correctly located, the
cover operates a micro-switch. If the
cover is not fitted, the appliance will not
operate.
stand & rotate it clockwise to lock it in
place (Fig. J).
raise the motor housing until it locks in
place (Fig. K).
micro-switch to prevent the appliance
working while the housing is raised.
beater (12) onto the Mixer drive shaft (1)
and rotate it clockwise to lock it in place
(Fig. L).
other liquid, dough hooks are for
kneading dough, whisk is for Light
mixtures e.g. Cream, eggwhites,
blancmange etc.
lower the motor housing until it locks in
place.
ENGLISH
9
Publicité
