Preparing the remote controller
This section is only for KD-SX992R.
KD-SX921R can also be remotely controlled with
an optionally purchased remote controller. We
recommend that you use remote controller
RM-RK50 with your unit.
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
Remote sensor
• Do not expose the remote sensor to strong
light (direct sunlight or artificial lighting).
Installing the battery
When the controllable range or effectiveness of the
remote controller decreases, replace the battery.
1.
Remove the battery holder.
1) Push out the battery holder in the direction
indicated by the arrow using a ball-point
pen or a similar tool.
2) Remove the battery holder.
(back side)
All manuals and user guides at all-guides.com
2.
3.
WARNING:
• Store the battery in a place where children cannot
• Do not recharge, short, disassemble or heat the
• Do not leave the battery with other metallic
• When throwing away or saving the battery, wrap it
• Do not poke the battery with tweezers or similar
DO NOT leave the remote controller in a place
(such as the dashboard) exposed to direct sunlight
for a long time. Otherwise, it may be damaged.
Place the battery.
Slide the battery into the holder with the + side
facing upwards so that the battery is fixed in
the holder.
Return the battery holder.
Insert again the battery holder pushing it until
you hear a clicking sound.
(back side)
reach.
If a child accidentally swallows the battery,
consult a doctor immediately.
battery or dispose it in a fire.
Doing any of these things may cause the battery to
give off heat, crack or start a fire.
materials.
Doing this may cause the battery to give off heat,
crack or start a fire.
in tape and insulate; otherwise, the battery may
start to give off heat, crack or start a fire.
tools.
Doing this may cause the battery to give off heat,
crack or start a fire.
CAUTION:
Lithium coin battery
(product number:
CR2025)
5