Sony SDC-XA1200ES Mode D'emploi page 8

Connecting a digital
component (COAXIAL)
When you connect an MD deck or another
digital component through the DIGITAL (CD)
OUT COAXIAL connector, you can make a
digital recording.
Use a coaxial digital cable for this connection.
Be careful not to bend or twist the coaxial cable.
Coaxial digital cable (not supplied)
2CH OUT
L
R
To CD coaxial digital input connector
on an MD deck, etc.
GB
8
ANALOG DIGITAL(CD)
5.1CH OUT
FRONT SURROND CENTER
L
OUT
COAXIAL OPTICAL
R
SUB
WOOFER
Connecting a digital
component (OPTICAL)
When you connect an MD deck or another
digital component through the DIGITAL (CD)
OUT OPTICAL connector, you can make a
digital recording.
Use an optical digital cable for this connection.
When connecting the optical digital cable to the
DIGITAL (CD) OUT OPTICAL connector,
push the cable plug in until it clicks into place.
Be careful not to bend or twist the optical cable.
Optical digital cable (not supplied)
ANALOG
2CH OUT 5.1CH OUT
FRONT SURROND
L
L
R
R
To CD optical digital input connector
on an MD deck, etc.
Note
Only the audio signals of conventional CDs can be
output from the DIGITAL (CD) OUT connectors.
Those of the Super Audio CD cannot be output through
the DIGITAL (CD) OUT connectors.
DIGITAL(CD)
CENTER
OUT
COAXIAL OPTICAL
SUB
WOOFER