ABATEC REC 502 Mode D'emploi page 5

Stop the water level 5‐10 cm before reaching the nozzle location and cut the hole for the nozzle according to the
drawing in manual.
For the nozzle installation coat the liner facing side of the gasket with Vaseline, secure the thread of hose
connector with Teflon tape and connect the hose to the nozzle, tighten with the hose clip. Adjust the hose clip
gently, not to break the clamp. Watch for any leakage. If there is a leakage, apply more tape and tighten the
clamp.
Fill half of the filter tank with water. Second half fill with the sand you can find in the pool kit.
Assembly the filtration set: valve, flange clamp, pressure gauge. Cover thread of hose connectors with Teflon
tape. Connect elements of filtration system according to the guidelines shown in manual of your pool model.
After completing this step, keep pouring water.
Stop pouring water when the water level is 5‐10 cm below the skimmer, to cut a hole in the place of skimmer.
Please make sure to prepare a hole in the geotextile material before.
Fit the skimmer frame and thread it gently into the skimmer through the liner, for easier location of the skimmer
placement. Do not cut the liner before the frame is screwed, the cut may shift and the hole may not fit the frame
when it's screwed on.
Cut the hole, then remove the frame and install all skimmer elements in their place according to the drawing
from the manual.
Make sure you connect all filter elements with hoses according to the instructions and continue filling with water.
To ensure proper work of the filter set, top up the water level in the pool, to the half of the skimmer!
Place the pool decking boards according to the diagram presented in the manual.
To assemble the movable board (for easy access to the skimmer), use the hinges included in the set.
FILTRATION SYSTEM
SKIMMER INSTALLATION
INSTALLATION OF THE TERRACE BOARDS