ABATEC REC 502 Mode D'emploi page 3

In order to prepare pool for the winter season (especially if there is a risk of freezing water) use a plug dedicated
to shut the access of water to filtration system. Inlet must remain in the pool. Fix a plug under water. Remember
to disconnect filtration set from source of water and dry the inlet (the part of inlet which is outside the pool). For
winter season, it is recommended to get rid of water remaining in pump and sand filter, otherwise freezing water
can cause devastation of whole set.
Partly or fully in‐ground pool must be secured in accordance with documentation enclosed in pool manual. Please
see the drawing in the manual.
Wooden structure protection required:
1 – FOUNDATION
2 – DRAINAGE PIPE
3 – FOUNDATION BUBBLE WRAP
4 – GRAVEL
5 – GEOTEXTILE
6 – GROUND
In order to define the area for the pool, place the first layer, then remove it to prepare the area.
When preparing the area for the pool, remove grass, roots and stones.
The ground on which the pool is situated should be stable, solid, flat and, above all, levelled on the entire surface.
For the pool models without steel supports apply sand stabilized with cement or concrete screed.
For the pool models with steel supports, concrete base must be prepared in accordance with the diagram
presented in the manual.
Manual guidelines for the arrangement of 2T posts and preparation of reinforced concrete screed must be strictly
followed. All dimensions must comply with the manual guidelines.
We recommend that concrete floor is laid by specialized companies!
The assembly of the structure starts with the first layer.
After arranging each layer, check the diagonals according to the drawing in the instruction.
RUBBER PLUG
GROUND PREPARATION
WOODEN STRUCTURE ASSEMBLY