ABATEC REC 502 Mode D'emploi page 4

To ensure that connections of tongues and grooves in construction planks are precise and tongues are not
damaged, it is necessary to use a wooden knocking block. Hitting directly against the elements of the tongue or
groove is unacceptable. Damages arising from this preclude the proper folding of the elements or reduce their
durability.
Continue to assemble of all wooden elements in the order shown in the instructions.
OPTION → If your pool has a lighting option, install the lamp in the pool structure in accordance with the
additional instructions attached to the lamp.
Assemble all elements of a complete skimmer, and secure the threads with Teflon tape.
Note!
The moment of placing the skimmer in the wooden structure depends on the skimmer model. Perform this step
according to the instructions in your pool's manual.
Skimmer should be screwed in the wooden structure in the indicated in manual time of installation and in
indicated places. Cover the diffuser surfaces with double‐sided tape and stick the gasket.
Distribution of geotextile starts from the inner side of pool walls, for installation use double‐sided tape or glue.
Prepare holes for the skimmer and nozzles.
PVC profiles for liner installation cut to the indicated dimensions. Pay attention to the required angles. According
to the diagram prepare the holes ∅ 2 mm. Mount the profiles to the structure by connecting them along the
entire pool. Plan profiles distribution to make as few joints as possible.
Spread the geotextile evenly over the pool floor, then start installing the liner (pool foil) in PVC profiles.
It is recommended to store the liner in its original packaging in a dry room at a moderate ambient temperature
(15‐25 degrees Celsius). Warm temperature makes liner material more manageable.
When installing the liner into the pool structure, make sure that joints and welds are perfectly distributed in the
corners of the walls. Smooth all the folds. Pay attention to the places on the holes for lamp, nozzle, skimmer.
Install the liner in PVC profiles using liner lock.
When pouring water, straighten the liner on the ground with bare feet, level out any unevenness that may occur,
at the same time stretch the liner walls down to the ground (pay great attention to the corners).
Pool water should be poured gradually, as indicated in manual.
SKIMMER ASSEMBLY
PREPARATION OF THE INNER SIDE OF THE POOL