Adjustments - Ryobi DP103L Manuel D'utilisation

Perceuse à colonne de 254 mm (10 po)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Before performing any adjustment, make sure the tool is
unplugged from the power supply. Failure to heed this
warning could result in serious personal injury.
ADJUSTING TABLE HEIGHT
See Figure 19, page 21.
 Hold the table with one hand and loosen the table lock
handle.
 Rotate the table adjustment handle clockwise to raise the
table.
 Rotate the table adjustment handle counterclockwise to
lower the table.
 Position the table to the desired height and retighten the
table lock handle.
ADJUSTING TABLE BEVEL
See Figures 20 - 21, pages 21-22.
The drill press is equipped with a tilting table that allows
you to drill angled holes. The table can be tilted left or right,
from 0º to 45º.
To tilt the table:
 Loosen the large hex bolt located underneath the table.
 Use the bevel scale to tilt the table to the desired angle.
 Retighten the hex bolt securely.
ADJUSTING DEPTH GAUGE
See Figure 21, page 22.
Adjust the depth gauge when you need to drill a number of
holes to exactly the same depth.
 Loosen the depth stop locking collar.
 Rotate depth gauge to desired setting.
 Retighten depth stop locking collar, if needed.

ADJUSTMENTS

CHANGING SPEEDS
See Figure 22, page 22.
The spindle speed is determined by the location of the belt
on the pulleys inside the head assembly. The speed chart
located on the cover inside the head assembly shows the
recommended speed and pulley configuration for each
drilling operation.
To change the pulley configuration:
 Lift head assembly cover from front to open.
 Loosen the tension bolt.
 Remove the drive belt.
 Reposition the belt according to the speed chart.
 Retighten the tension bolt.
14 - English

Publicité

Table des Matières
loading

Table des Matières