Ryobi SwiftClean PCL756 Manuel D'utilisation page 7

This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
CLEANING/REPLACING THE FILTER
See Figure 12, page 9.
 Remove the battery pack.
 Remove the waste tank as described earlier in Remov-
ing/Emptying/Reattaching the Waste Tank.
 Remove the filter from the bottom of the unit
NOTE: To reassemble, insert filter into filter housing.
 Shake or lightly brush any dust or dirt off the filter.
 Wash with clean, fresh water.
 Empty the waste tank; wash if necessary. Before reat-
taching to the unit, make sure all pieces are completely
dry.
NOTE: Allow 24 hours for parts to dry completely.
When purchasing replacement filter, request recommended
part number 904059001.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
CLEANING THE ROLLER BRUSH
See Figures 13 - 14, page 9
Sometimes hair or strings can become tangled around the
roller brush and prevent it from cleaning properly. Periodic
removing and cleaning of the brush will keep the unit at its
peak performance.
 Remove the battery pack.
 Using a coin, remove the locking cap by rotating counter-
clockwise until the arrow aligns to the unlocked position
on the head of the unit.
 Pull on the cap to remove the brush from the unit. Some
resistance may be felt from the bristles. This is common.
 Use scissors to remove the hair or strings as shown.
 Reinsert the brush.
NOTE: Be sure to align the other end of the brush with
the post inside the head of the unit.
 Align the arrow on the cap with the unlocked position on
the head of the unt.
 Use the coin to push down and rotate clockwise until it
is in the locked position and the brush is secured firmly
in place.
STORING THE SPOT CLEANER
 Remove the battery pack.
 Remove, rinse, and dry the solution tank and the waste
tank, if necessary.
NOTE: Allow 24 hours for parts to dry completely.
 Install both tanks onto the unit.
 Store the unit in a dry place out of the reach of children.
NOTE: Always store the unit in a horizontal position to
avoid any residual water from entering into the motor.
 Store the battery in a separate location and out of the
reach of children.
7 — English