Publicité
Les langues disponibles
Les langues disponibles
STEP 6 PREPARING THE DISHWASHER
1. Ensure that the circuit breaker and water supply valve are turned off before proceeding with
the following steps.
Before you move or lay down the dishwasher for installation, make sure to adjust the height
of the legs so the legs are as short as possible. This prevents the legs from breaking.
CAUTION
Level the dishwasher by adjusting the height of the legs after you have the dishwasher in
place.
2. Wrap Tefl on tape around the threads of the 90˚ elbow, and then attach the elbow to the
Inlet valve (Figure 4 - B). Tighten until the elbow is tight and pointing towards the water hose
channel in the base of the dishwasher (about 4 o'clock). To prevent the inlet valve from being
blocked, make sure that the Tefl on tape does not enter the valve. Do not over tighten.
3. Cut the strings securing the drain hose to the back of the dishwasher. Roll-out the hose.
Make sure there are no kinks and that the hose is not bent at any extreme angles that could
constrict the fl ow of water.
4. Remove the junction box cover located at the bottom front right of the dishwasher using a
screwdriver, and then Install the strain relief (Figure 4 - C). Make sure to keep the junction box
cover you removed. It is used in Step 10, Wiring Connections.
5. If the countertop is made of wood or a material that is not damaged by drilling, attach the
two (2) Installation brackets that were supplied with the dishwasher using the supplied
screws (Figure 4 - A). They will be used in Step 8, Securing the Dishwasher.
6. Use the provided clamp to connect the provided drain hose to the outlet at the back of the
product. If the product has the drain outlet in the right side, use the provided holder hose to
facilitate the connection.
Insert the clamped drain hose into the holder hose.
Tighten the clamp in the right position.
The clamp is improperly connected.
To prevent damage to the drain hose that is designed to pass
the product to the right, use the provided hose fi xer to secure
the middle area of the drain hose to the product.
If drain hose is not connect completely, it can be the cause of "OE" ERROR.
CAUTION
installation_DW80H9950US-00151A-02_EN_140811.indd Sec3:13
installation_DW80H9950US-00151A-02_EN_140811.indd Sec3:13
All manuals and user guides at all-guides.com
Bad
Good
Tighten the clamp in the center of the
assembly position.
installing the dishwasher _13
2014-08-11
2014-08-11
7:39:30
7:39:30
Publicité
