APEX FORGE M6 Mode D'emploi page 17

aside. The original housing cap must be reinstalled when this attach- ment is not
used (Fig.1).
Step 2. Screw the Shield onto the tool using the lock nut B (Fig.2).
Step 3. Position the Shield such that it will redirect debris, sparks, and dust away
from the user using the positioning tabs C (Fig.3).
Using the Shield Rotary Tool Attachment:
Always turn the tool off before adjusting position, changing accessory and removing
attachment. Rotary Tools cut, sand, grind, and polish in many directions. To
accommodate the Rotary Tool's Maneuverability, the Shield can be quickly
positioned and repositioned with a turn to the right or left .To extend the life of the
Shield periodically clean with a soft bristle brush or compressed air.
Fig.1
A
Fig.3
C
Flexible Driver Attachment
Safety Rules for Flexible Driver
Do not operate the flexible shaft with a
sharp or multiple bends. Ensure that
there are no sharp residual bends
orkinks in the Flexible Driver before the
operation.Over bending the shaft can
generate excessive heat on the jacket or
hand piece and may cause the Flexible
Fig.2
C
- 15 -
6"(15 CM) Min.
B