APEX FORGE M6 Mode D'emploi page 11

Removing Accessories
●Unplug the rotary tool.
●With the shaft lock (E) engaged, loosen
the collet nut (B) with the provided wrench
(A).
●Remove the accessory.
Using Mandrels
The most common types of mandrel to use with this tool are the standard mandrel
which is used with cutoff discs, grinding wheels, emery wheels, and cut-off wheels.
Screw mandrels are used with polishing wheels and polishing drums. Drum mandrel
are used with sanding drums.
To install:
●
Unplug the rotary tool
●
Install the mandrel.
If using the standard mandrel:
●Press and hold the shaft lock button (E).
●Insert the slot end of the provided
wrench into the slot on top of the mandrel
and unscrew.
●Remove mandrel screw and washer.
●Place desired accessory over mandrel
shaft and align accessory hole with
mandrel hole.
●
Insert mandrel screw with washer through the accessory and mandrel shaft
holes.
NOTE: The mandrel washer should be placed between the mandrel screw and the
accessory.
●
Tighten using provided wrench.
A
- 09 -
E
B