APEX FORGE M6 Mode D'emploi page 10

Functions Description
On / Off Switch
This product has an easy access power
switch (F) located at the top of the tool. To
turn the tool ON, push the ON/OFF (I / O)
switch (F) to the ON (I) position.
To turn the tool OFF, push the ON/OFF (I / O)
switch (F) to OFF (O) position.
Replacing Collets
Using collets is the most precise way to hold an accessory in a high speed rotating.
Even at high speeds and maximum pressure, collets stay tight.
●Unplug the rotary tool.
●Press and hold the shaft lock button(E), and
rotate the shaft with the provided collet wrench
(A) until the shaft lock (E) engages the shaft,
preventing further rotation.
●With the shaft lock (E) engaged, use the collet
wrench (A) to loosen the collet nut (B), if neces-
sary.
●Remove the collet nut (B) and old collet (C)
using collet wrench (A), if necessary.
●Insert the unslotted end of the new collet (C) in
the hole in the end of the tool shaft.
●Tighten the collet nut with the collet wrench (A)
Installing Accessories
WARNING
Do not press the shaft lock button (E) while rotary tool is running.
●
Unplug the rotary tool.
●
Press and hold the shaft lock button(E), and rotate the shaft by hand until the
shaft lock engages the shaft, preventing further rotation.
●
With the shaft lock button engaged, use the collet wrench (A) to loosen the collet
nut (B), if necessary.
●
Insert the shank of the accessory into the collet as deep as possible. With the
shaft lock button(E) engaged, tighten the collet nut (B) with the provided wrench
(A) until the accessory shank is gripped by the collet. Avoid excess tightening of
the collet nut (B).
A
- 08 -
F
E
B