IMER SPIN 30 PLUS Mode D'emploi page 15

California proposition 65 message
Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contain chemicals know (to the
State of California) to cause cancer, birth defects or other repro-
ductive harm. Some examples of these chemicals are:
-Lead, from lead-based paints
-Crystalline silica, from bricks and cement and other masonry
products
-Arsenic and chromium, from chemically treated lumber
For further information , consult the following sources:
http://www.osha.gov/dsg/topics/silicacrystalline/index.html
http://www.cdc.gov/niosh/docs/96-112/
http://oehha.ca.gov/prop65/law/P65law72003.html
http://www.dir.ca.gov/Title8/sub4.html
http://www.P65warnings.ca.gov
PROBLEMS
Machine does not start Electric current
- No current delivered to connector of site panel (fuses?)
- No power delivered to machine
(defective connector connection? loose cable?)
- Main ON/OFF (thermal cutout) switch not turned on
- Main switch/inverter (3-PHASE version only) set to position 0
- Mixing chamber open
(thermal magnetic switch does not engage)
- Emergency pushbutton pressed (release)
Thermal cutout trips on Material in hopper
start-up - Material has hardened in the hopper
- The type of material requires more water for mixing
Material consistency not Water supply insufficient
constant; too hard or too - Water hose bent
fluid - Pump inlet water filter clogged
- Pressure reducer water filter clogged
- Pressure reducer faulty
The water continues to exit Solenoid valve faulty
from the mixing chamber
when machine is
stationary
Material does not exit the Mixing chamber clogged
offload port - The container used for offload is too high and does not enable
the material to flow out
- The offload port is clogged
Mix not optimal The type of material used is not suitable
- Not all products on the market can be mixed with this type of high
speed mixing system
- Mixing shaft worn
INDICATOR LIGHT
All manuals and user guides at all-guides.com
IMER INTERNATIONAL S.p.A.
SPIN 30 PLUS
CAUSES
ON
15
Your risk from these exposures varies depending on how often you do
this typer of work. To reduce your exposure to these chemicals, work
in a well-ventilated area, and work with approved safety equipment,
such as dust masks that are specially designed to filter out microscopic
particles. Where use of a dust extraction device is possible, it should be
used. To achieve a high level oof dust collection, use an industrial HEPA
vacuum cleaner. Observe OSHA 29 CFR part 1926.57 and 1926.103
CORRECTIVE ACTION
- Check points listed alongside
- Completely empty the hopper and restart with new material
- Increase the quantity of water delivered
- Check points listed alongside
- Contact an authorised IMER service centre
- Check points listed alongside
- Consult the material manufacturers to check compatibility
- Replace shaft
OFF