fadini Hindi 880 evo Notice D'instructions page 17

HINDI 880 - evo
PREPARING THE FIXING PLATES
First weld the front and rear fixing plates to the patching plates (Pic. 5), after assessing the installation measurements as indicated
in Pic. 6 and Pic. 7 (or in Pic. 8, in the case where opening is required to be outwards).
Reinforcement patching plate
installations, it is recommended
to provide a plate adequate to the
This distance
depends on B
(Pic. 7 and Pic. 8)
IMPORTANT: in case of heavy gates, it is recommended that
!
fixing to the gate post and gate leaf be stronger by providing
rigid patching plates (not supplied by the manufacturer).
Misalignment between post- and gate-fixings:
universal oil-hydraulic operator for swing gates
(optional). With heavy
gate type.
HINDI 880-evo: stroke 150 and 280 mm
HINDI 880-evo: stroke 400 mm
Make sure the operator
is levelled in all
directions before fixing it
Rear fixing
17
Front WARNING:
fixing if any welding is carried
out to complete the front
fixing with Hindi 880-evo
installed,
make sure the shaft is
suitably protected.
23 mm
35 mm
!
Pic. 5
Pic. 6