TensCare Allura Mode D'emploi page 26

PROGRAMME CONTROL
The button illustrated is the
programme control. The Allura
has eight different, specially
developed programmes. When the unit
is first switched on it automatically
enters the programme FACE 1.
Each time you press and release the
PROGRAMME CONTROL button, the
programme changes and is shown on
the LCD.
Each time you change the programme,
the strength level reverts back to zero.
This is a safety feature to alleviate any
sudden feeling of a surge, as each
programme gives a different sensation.
PHASE SKIP
All the programmes except
FACE 1 have seven phases.
The bar column in the middle of the
display increases as each phase starts:
Phase 1 Phase 2
And so on up to the 7
This button can be used to skip a
phase. Press and hold this button for 3
to 5 seconds to skip and go to the next
phase of the selected
session.
LOW BATTERY
An empty battery symbol will
show when
change the batteries. The unit will shut
down about 2 minutes after this.
Phase 3
th phase (7 bars).
treatment
you need to
KEYPAD LOCK
If you do not press any keys for 30
seconds, the keypad will lock so
that only the keys marked CH1▼
or CH2▼ will work. This is to avoid
accidental changes in setting. To
unlock, press either CH1▼ or CH2▼
keys.
OPEN CIRCUIT CUTOUT
If the Allura is not correctly connected
to your body, the strength in the
channel which
connected will automatically reset to
zero. This is to prevent sudden changes
if a broken connection is re-made.
MEMORY
The Allura has a Memory with three
functions:
1) Programme Retention. When you
switch the unit on, it will automatically
start in the programme which was being
used when it was switched off.
2) Usage. Press the phase skip button
and CH1▼ together and hold down for
3 to 5 seconds. The display will show
the number of times used and duration
in hours used.
Press the same buttons again to return
to normal controls.
3) Memory Reset. To reset memory to
zero, hold down the phase skip and
power buttons together for 3 to 5
seconds.
25
is not properly