RCA RCR311B Mode D'emploi page 9

Get user manuals: See SafeManuals.com
1. Manually turn on the component you want the remote to
control (TV, VCR, DVD, satellite receiver or cable box).
Note: If you press an invalid key during the Auto Code
Search, the remote does not respond and the illuminated
ON•OFF key does not blink. If you do not press a valid
Auto Code Search key (TV, VCR•DVD, SAT•CBL, ON•OFF,
GO BACK, PLAY, REVERSE, STOP), the search times out
after two minutes. When the search times out, the illuminated
ON•OFF key blinks four times and turns off. The last
programmed code under that component key is retained.
2. If you are programming your TV or satellite receiver, go
directly to step 4.
3. To program the remote to control a VCR or DVD. The
VCR•DVD key can control only one component, either your
VCR or your DVD. To program your remote to control
either your DVD or your VCR, you must first put the
remote in the proper programming mode. Follow these
directions before proceeding to step 4.
a. Press and hold the VCR•DVD key.
•
VCR DVD ON•OFF
The illuminated ON•OFF key
turns on.
b.While holding down the
(BLINK)
VCR•DVD key, press and release
the number 2 key on the keypad to
•
VCR DVD
control a VCR or the number 3 key
to control a DVD. The illuminated
ON•OFF key blinks, and then turns
back on.
c.Release the VCR•DVD key.
• The illuminated ON•OFF key
VCR DVD ON•OFF
blinks four times and then turns
off. Your remote is now either in
VCR or DVD Programming Mode,
depending on which you chose.
(BLINK)
Proceed to step 4.
4. Press and hold the component key
•
VCR DVD
(TV, VCR•DVD, SAT•CBL) you wish
•
TV
SAT CBL
to program. The illuminated ON•OFF
key turns on and remains on.
ON•OFF
5. While holding the component key
down, press and hold the ON•OFF
key. The illuminated ON•OFF key
turns off.
(BLINK)
6. After holding down both keys for
•
ON OFF
three seconds, the illuminated
ON•OFF key turns back on.
7. Release both keys. The illuminated
ON•OFF key remains on.
Throughout the programming of each key, be sure to
TIP:
keep the remote pointed at the IR sensor of the component you
are currently programming the remote to control.
8. Press and release the PLAY key,
PLAY
then wait five seconds to see if
your component turns off. If your
component does not respond,
continue to press the PLAY key
ON•OFF
every five seconds until your
component turns off. Each time you
press the PLAY key, the illuminated
ON•OFF key blinks and a block of
(BLINK)
10 codes are sent to your component.
This process continues until all of
the codes in the Code Lists have
been searched. (If your component
has not turned off after all codes have
been searched, the illuminated
ON•OFF key blinks four times and
turns off. The Auto Code Search
Entry method is exited.)
9