Publicité
Les langues disponibles
Les langues disponibles
Dipswitch 10 on the first (Master) unit is no use for the 2-light show as it is the master unit
that operates the light show.
4.3 Easy Controller (by CA-8/ CA-9)
The easy remote control is used only in master/slave mode. By connecting
to the 4-pin jack of the first unit, you will find that the remote controller on
the first unit will control all the other units for Stand by, Function and Mode
selection
Stand by
Blackout the unit
1.Synchronous Strobe
2. Two light Strobe
Function
3. Sound Strobe
Mode
Strobe (LED OFF)
4.4 Universal DMX Controller
When using a universal DMX controller to control the chain of units, you have to set DMX
address by Dip switches from 1 to 9 to make sure all the units will receive its DMX signal.
The dip switch 10 is used to choose channel mode. Please refer to the following diagram to
know how to address your DMX 512 system in the binary code.
DMX 512 Address Chart
Dip-switches
# 1
Value
Examples:Unit 1：dip / on: #1 (=1)
Unit 2：dip / on: #2, #3 (2+4=6)
Unit 3：dip / on: #1, #2, #4 (1+2+8=11)
Unit 4：dip / on: #5 (=16)
# 2
# 3
1
2
4
Select show
Show(LED ON)
# 4
# 5
# 6
8
16
32
Select Gobo
LED blinking
# 7
# 8
# 9
64
128
256
#10
2-Light show
Publicité
