Publicité
Les langues disponibles
Les langues disponibles
1. Safety Instruction
Please read the instruction carefully which including important information about the
installation, operation and maintenance.
Please keep this User Manual for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
The unit is for indoor use only and use only in a dry location.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect mains power before fuse replacement or servicing.
Replace fuse only with the same type.
Make sure there are not flammable materials close to the unit while operating as it is fire
hazard.
Use safety cable when fixes this unit.
Maximum ambient temperature is TA: 40℃ and don't operate it where the temperature is
higher than this.
Unit surface temperature may reach up to 60℃. Don't touch the housing bare-hand during
its operation.
There are no user serviceable parts inside the fixture. Do not open the housing or attempt
any repairs by yourself. In the unlikely event your fixture may require service, please contact
the nearest authorized technical assistance center and always use the same type spare
parts. .
Don't connect the device to any dimmer pack or power pack.
Do not look at the beam light directly in order to avoid visual problems
Please pay attention to the LED emissions that can cause eyes sensibility.
The housing must be replaced if they are visibly damaged.
Do not touch any wire during operation as high voltage might be causing electric shock.
2. Technical Specification
It can be operated by DMX512 control or can be used as an individual unit without controller.
Please use a 3 pin XLR cable/plug when link in master/slave mode.
Publicité
