Before First Use - SOLAC AE2550 Mode D'emploi

AE2550.book Page 16 Thursday, November 14, 2013 5:37 PM
BATTERY CHARGING (A)
p
Do not use any chargers other than the one supplied.
Z
All repairs or battery replacements should be performed by an Authorised Technical Service.
Z
When charging, the charger heats up slightly. This is normal, unless it heats up excessively.
Z
Before the first use, it is advisable to charge the batteries completely. This charge will take 5
hours.
1 Set switch (3) to the O – "Off" position
i
It will also charge if the switch is left in position I or Turbo (II). However, when the unit is
unplugged in this position it will start automatically. Make sure switch (3) is in the O position
before unplugging the charger cable.
2 Place the vacuum cleaner in a stable position. To do this:
Slot the catch located on the joint between the main body and the suction head (20) into its
housing and insert the rear of the handgrip into the wall mount (26), the vacuum cleaner will
remain upright
3 Plug the charger cable (25) into the charge connector (8)
4 Plug the charger into the mains socket
i
The LED indicator (2) will light red while it is charging. When the charge is between 80 to
100% it will flash green and will switch off when the charge is completed.
5 After charging, unplug the charger from the wall socket and the unit. Store it in a safe place for
future charges. The unit is now ready for use.
RECOMMENDATIONS TO PROLONG BATTERY LIFE
• Do not leave the charger connected for extended periods of time. Unplug it after charging.
• LITHIUM-ION batteries do not have the memory effect. After each use, charge the vacuum cleaner
for maximum battery usage time.
• Do not store or charge the appliance near radiators or other sources of heat, or exposed to direct
sunlight.
• Do not charge the appliance in dirty or wet places. The room temperature should be between 0 ºC
and 37 ºC.

BEFORE FIRST USE

Z
Remove all elements used for transport and packaging.
1 Insert the handle (18) into the main body (1) and lock both parts using the retaining screw (5)
(B).
2 Make sure the dust container (11) and filter assembly (15) are fitted correctly. See "Cleaning
dust container and filters"
3 Insert the head (20) into the suction nozzle and push it inward until you hear a click.
To remove it, press the suction head lock/release button (21) and pull it out. (C).
16 BEFORE FIRST USE