Alice's Garden FOUCAULT Manuel D'utilisation page 29

ADVICE IN CASE OF A FAILURE
PROBLEM THE CAUSE
The safety button / restart button hasn't
come on
The gas valve is closed / The gas canister
is empty
The opening or tube of the diffuser is
obstructed
There's air in the gas pipe.
The burner
doesn't light
The piezoelectric ignition isn't working
/ the burner
doesn't stay lit
A build-up of dirt around the burner
There's a loose connection between the
gas valve and the pilot light.
The gas pressure is low
The opening is obstructed
The power switch isn't set to « MAX » or
« MIN »
The lateral burner doesn't light
The side burner
The piezoelectric ignition isn't wor king
doesn't light
The gas pressure is low
The burner
The exterior temp. is greater than 5°C and
flame is weak
the tank only fills itself to 1/4
Note: Don't use
The gas hose is twisted or doubled over
the apparatus if
the exterior temp
is less than 5°C
The power switch is completely open
(« MAX » or « MIN »)
The burner
The gas pressure is low
flame isn't
uniform
The barbecue isn't on a flat surface
Note: the lower
part, 2,5cm
from the burner
There's a build-up of dirt on the burner
doesn't normally
light up
Build-up of
Dirt or film on the burner or diffuser
carbon
Thick black
The burner is obstructed
smoke
04/11/2022
THE SOLUTION
Push the restart button, to start the flow of gas.
Open the valve / Replace the gas canister
Clean the opening with a brush or a fine paint
brush
Open and purge the gas tube (keep pushing the
power switch for 1-2 minutes or until you can
smell gas)
Use a match the light the pilot light. If it lights, get
a new ignition and replace the non-working one.
Clean the burner
Tighten the connection and check to see if
there's a leak
Attach the gas cylinder again
Clean the opening
Turn the switch to « MAX »
Check that all the parts are in the right place
Check the cable is well connected
IW01
Check if the metal rod of the cable
tioned regard to the burner
Reconnect the gas cylinder
Reconnect the gas cylinder
Untwist the gas hose and check there is no leak
Turn the button to « OFF », let the apparatus
cool down and make sure that the burners and
the holes aren't obstructed.
Reconnect the gas cylinder
Put the barbecue on a flat surface
Clean the burner
Clean the burner of the diffuser
Turn the button to « OFF », let the apparatus
cool-down, clear any obstructions and clean the
exterior and interior of the apparatus
EN
is well posi-
IW01
29