Publicité
Les langues disponibles
Les langues disponibles
HYDRALVAC 6000 / HYDRALVAC OXYDROSS
INTRODUCTION
It is recommended, in order to facilitate your subsequent orders for spare parts (if required) and for any
information requests concerning your HYDRALVAC 6000 or HYDRALVAC OXYDROSS, to write on this page
the characteristics which are marked on the identification plate, as soon as you receive the equipment.
Type HYDRALVAC/ OXYDROSS
Serial number
Use
Use in accordance with its intended purpose : the HYDRALVAC 5000 is a system used to inspect presence or no of gas
in the fused aluminium, putting a sample under vacuum.
Characteristics
Power supply
Motor power
Length (mm)
Width (mm)
Height (mm)
Net weight (kg)
Sound level (db(A))
OPERATION
Handling and storage
For the handling of the HYDRALVAC 6000 or HYDRALVAC OXYDROSS, there are two carrying handle on top of the box.
The slope of the ground where the HYDRALVAC 6000 or HYDRALVAC OXYDROSS is installed must not be
more than 5°.
Before each moving, check that the vacuum bell jar can't fall and break.
If there is a long time between the delivery and the application, store the HYDRALVAC 5000 in suitable conditions (in
dry, dust‐free room and where it won't be subject to vibrations).
Use place and temperatura
The HYDRALVAC 6000 or HYDRALVAC OXYDROSS must be installed in a well ventilated, dust‐free room where there is
no risk of freezing to avoid the solidification of the lubrication oil. The ambient temperature must not exceed 40°C and
should be in the range of +10°C and +30°C.
520499-05
HYDRALVAC 6000
230V single phase – 50Hz / 60Hz
120W – 1.2A
340
340
345
18
48
HYDRALVAC OXYDROSS
230V monophasé ‐ 50Hz / 60Hz
370 W – 3,4A
445
337
341
24.2
52
9
Publicité
