Pioneer BCS-424 Mode D'emploi page 62

62 Advanced settings
En
 Adjusting the video
1. Select and set Display Setting d Video
Adjust d Next Screen.
Use / to select, then press ENTER.
2. Select the item and change the setting. Use / to select the item, then use /
to change the setting. Once the setting is
completed, press
settings screen.
Item Description
Brightness Select this to adjust the TV screen's
brightness.
Contrast Select this to adjust the TV screen's
contrast.
Hue Select this to adjust the color (green
and red) balance of the TV screen.
Saturation Select this to adjust the TV screen's
saturation.
 Adjust speaker settings
1. Select and set Audio Output d Speaker
Setup d Next Screen.
Use / / / to select, then press ENTER.
2. A picture of speakers will be shown on
the screen. Select the speaker using
cursor and press ENTER.
3. Use / to select Trim or Delay and
then press ENTER.
4. Use cursor / to adjust the setting,
then press ENTER.
 Adjust speaker settings while listening
to a sound
1. Select and set Audio Output d Test
Tone d Next Screen.
Use / / / to select, then press ENTER.
8
2. A test tone will be output. The speakers
will switch automatically.
3. A picture of speakers will be shown
on the screen. Press ENTER when
the speaker you wish to adjust to is
focused.
4. Use / to select Trim or Delay and
then press ENTER.
5 Use / to adjust the setting, then press
*1ms = 30 cm
ENTER.
All manuals and user guides at all-guides.com
RETURN to close the
 Setting the IP address
1. Select and set Network d IP Setting d
Use / to select, then press ENTER.
Next Screen.
2. Set IP address. Use / / / to set the IP address of the
player or DNS server, then press ENTER.
y Auto Set IP Address
On – The player's IP address is obtained automatically. Select this when using
a broadband router or broadband
modem that has a DHCP (Dynamic Host
Configuration Protocol) server function.
This player's IP address will automatically
be allocated from the DHCP server.
manually. Use the number buttons (0 to Of – The player's IP address must be set
9) to input the IP address, subnet mask
and default gateway.
Note
y For information on the DHCP server function,
refer to the operating instructions for the
network device.
y You may need to contact your Internet service
provider or network administrator when
inputting the IP address manually.