EGAmaster AQUAMASTER Manuel D'instructions page 51

SAFETY INSTRUCTIONS FOR PREVENTION OF PROJECTILE HAZARDS
Wear impact-resistant safety goggles (EN 166) – This refers to the operator, as well
as for the persons within the vicinity of the machine. Assess and determine the grade of
protection required depending on the individual case. The risks to others should also be
assessed at this time.
On overhead work, wear a safety helmet (EN 397). If a work piece, accessories,
inserted tools, or the tool itself breaks, there is danger from high velocity projectiles.
· Before using the machine check all parts for damages.
· Replace damaged parts immediately.
· When working on brittle material make sure that you are protected against harmful splinters.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Use only machine tools, accessories and consumables, which are recommended by the
manufacturer. Make sure choosing the correct size and the correct type. Use only accessories,
which are in proper condition.
CAUTION – Injury due to carelessness!
CAUTION –If the machine is fixed to suspension equipment make sure that it is
secure. Never hang the machine onto the supply line.
· Separate the machine form any external energy source before changing the
machine tool or an accessory.
· Avoid direct contact with the machine tool during and after use as it can be hot or
sharp.
· Wear protective gloves when changing a tool or an accessory!
Notice: Defective/ inappropriate gloves can lead to injury. Only wear proper hand protection,
adapted to the work place requirements.
WARNING – Explosion hazard!
When operating the machine in areas exposed to explosion hazards, use only
accessories, respectively devices, which are ATEX approved and specified.
SAFETY INSTRUCTIONS FOR PREVENTION OF TRANSPORT HAZARDS
ATTENTION – Improper Transport, danger of life due to parts falling down!
Damage of the machine!
· Separate the machine form any external energy source before transportation.
Check that the machine is undamaged and in proper condition.
· Never carry the machine at the supply line.
Wear worker's protective shoes!
51