EGAmaster AQUAMASTER Manuel D'instructions page 43

Hammer drilling
Fig. 3.1: Pull back the adjusting sleeve and lock it in clockwise direction.
Fig.3.1
Fig. 3.2: Pull back the sliding sleeve and insert the drill. Turn until the sliding sleeve returns
into the initial position. Press the machine against the work surface before switching it on,
otherwise the tool will not hammer. If the drill sticks in the hole, withdraw and reinsert it several
times when drilling.
Do not exert undue pressure on the machine - this will not increase its performance. Just
position the bit and guide it into the hole. For hammer drilling do not use any quick-release
chuck. (see fig. 3.4 and 3.5).
Fig. 3.3: When starting to drill in brittle material (tiles, etc.): Unlock the adjusting sleeve. Hold
and continue to drill the hole, then switch off the machine briefly and relock the adjusting sleeve.
Fig. 3.3
Drilling only
Fig. 3.4: Unlock the adjusting sleeve. It is possible to use a quick-release chuck at this
setting.
STARTUP
Fig.3.2
Fig. 3.4
43