Attaching Estore - Dometic eStore Instructions De Montage Et De Service

Attaching eStore

7 Attaching eStore
!
WARNING!
Do not secure the eStore using straps, or similar, passing over the
plastic eStore cover. This will result in damage to the unit.
I
NOTE
If you use multiple connected eStores: configure and mark eStore
number on each eStore before installation in the vehicle, see
chapter "Connecting multiple eStores" on page 19.
Observe the following instructions on installation location
 eStore can be installed vertically (fig. a, page 6) or horizontally (fig. b,
page 7), on a flat and stable surface.
 eStore must not be installed close to combustible materials.
 The installation location should be protected from moisture and dust.
 Leave at least 2 cm of space around eStore and ensure good ventilation.
The installation should avoid low temperatures during winter operation
(charging) to ensure continuous operation.
Avoid low temperatures during winter operation.
 For safety reasons, note the location of existing wiring harnesses, wires
and other components within the installation area, in particular those
which are not visible, when installing the eStore (when drilling or screwing
etc.).
 If you install more than one eStore, leave at least 1 cm of space between
the eStores.
➤ Select a suitable location and secure eStore safely.
➤ Vertical mounting: Use the integrated fixing feet to secure the eStore
(fig. a, page 6).
Suitable mounting brackets are available as accessories (see chapter
"Accessories" on page 12).
➤ Horizontal mounting: Secure eStore with two straps or bands across
the device (fig. b, page 7). Pass them between the handles and mount-
ing feet and fix them to the mounting surface. This will ensure the eStore
does not move when the vehicle is in motion.
Suitable mounting brackets are available as accessories (see chapter
"Accessories" on page 12).
16
eStore
EN