Publicité
Insert enclosed sponges in holes on door support and colour them (e.g. with a
·
flowmaster).
(Fig.1)
· Adjust the cabinet door and push them against the refrigerator door (sponges will
leave the impression marks).
· Drill the holes on the spot where you have the marks, remove the appliance door
support and screw it on the cabinet door.
· Screw the enclosed squares in already drilled holes on the lower side of the
appliance door.
· Hang the cabinet door back on the appliance door and screw them down from the
top side.
· Drill the holes into the cabinet door through squares and screw down with the
screws.
(Fig.3)
· In case of two-door appliance, repeat the whole fitting procedure on the second
door.
(Fig.2)
11
Publicité
