Publicité
Les langues disponibles
Les langues disponibles
UNDERMOUNT: STAINLESS STEEL
This sink is specifically designed to be undermounted in a solid surface countertop only.
CAUTION: Sink edge may be sharp; handle with caution. Do not install a damaged sink. Inspect carefully.
1. The size should be exact as this sink uses coordinating accessories which fit precisely in the cut out.
4
Sink flush with countertop.
2. Determine placement of the clip brackets as indicated on the template. Pre-drill holes according to method desired based on
countertop material. NOTE: You the fabricator may elect to epoxy in the screw or use a brass anchor.
3. Apply a bead of silicone evenly along edge on the underside of countertop.
4. Position and align sink over the opening. Press sink into silicone seal.
5. After re-checking alignment, tighten clip brackets against the sink edge.
6. Remove excess silicone.
HINT: After silicone cures, wipe inside edge with denatured alcohol. This will smooth out any rough areas.
NOTE: The template included (or dxf file downloaded from website) is only a guide. The actual sink and accessories should ALWAYS
be present to ensure a perfect cut. FRANKE is not responsible for an improperly cut countertop or improper installation.
UNDERMOUNT: STAINLESS STEEL
This sink is specifically designed to be undermounted in a solid surface countertop only.
CAUTION: Sink edge may be sharp; handle with caution. Do not install a damaged sink. Inspect carefully.
1. The size should be exact as this sink uses coordinating accessories which fit precisely in the cut out.
5
Countertop cut is top of bevel.
2. Determine placement of the clip brackets as indicated on the template. Pre-drill holes according to method desired based on
countertop material. NOTE: You the fabricator may elect to epoxy in the screw or use a brass anchor.
3. Apply a bead of silicone evenly along edge on the underside of countertop.
4. Position and align sink over the opening. Press sink into silicone seal.
5. After re-checking alignment, tighten clip brackets against the sink edge.
6. Remove excess silicone
HINT: After silicone cures, wipe inside edge with denatured alcohol. This will smooth out any rough areas.
NOTE: The template included (or .dxf file downloaded from website) is only a guide. The actual sink and accessories should ALWAYS
be present to ensure a perfect cut. FRANKE is not responsible for an improperly cut countertop or improper installation.
0714
No recessed countertop.
No recessed countertop.
No countertop overhang.
No countertop overhang.
FSSII0714
Publicité
