Publicité
Les langues disponibles
Les langues disponibles
Brewer Motor
1. Disconnect
harnesses and remove the brewer.
2. Remove the three large
securing the motor to the brewer
assembly.
3. Pull the motor straight out.
4. Secure the new brewer motor to the
brewer assembly with the three
screws.
5. Re-install the brewer and reconnect the brewer wiring harnesses.
Selection Ring & Board
1. With the cover open, remove the spill p late and spout.
2. Remove the two screws from the
retainer securing the selection ring
to the mainframe.
3. Remove the retainer, and pull out
the selection ring.
4. Disconnect the wiring harness from
the rear of the selection board and
pull the board out to remove it.
5. Slide the new selection board into position.
6. Install the selection ring and secure it to the mainframe by screwing the
retainer in place.
7. Connect the wiring harness to the rear of the selection board.
8. Install the spout and the spill plate.
Replacing Major Components
the
brewer
wiring
screws
TO RX
TO RX
TORX
Screws
Screws
45
Publicité
