VKI Technologies Espresso Cafe Manuel D'opération page 15

NOTE:
When the milk canister is empty, any selections requiring milk are
disabled and the green START button w ill not illuminate.
1. Open the milk door on the top left of the coffee maker.
2. Pull the empty milk canister straight out (if replacing).
3. Remove the canister lid fro m the empty canister.
4. Remove the freshness seal fro m the new milk canister.
5. Install the canister lid onto the new milk canister.
6. Install the new milk canister into the coffee maker by pushing it down into
the canister receptacle.
7. Close the milk door on the coffee maker.
NOTE:
When the milk canister is initially installed, or when it is replaced, the
milk dispenser motor may automatically activate to prime the milk through the
system. Once primed, the motor w ill stop automatically.
NOTE:
Do not install and remove the milk canister repeatedly as this will pack
the milk at the bottom of the auger and may cause it to jam. Once installed,
leave it in place until it is absolutely necessary to remove it.
Installing the Milk Canister
15