Uline H-5121 Guide Rapide

H-5121
MARINE SHRINK CART
TOOLS NEEDED
3/8" Combination Wrench
or Socket Wrench
A B
3/8" Nut x 8 Support Pole D-Clip x 4
1. Attach X-support pole (E) to the bottom of caster/
Frame (C) using 3/8" nuts (A). Tighten nuts firmly, but
not completely, in order to retain flexibility. Repeat
process for the other caster/frame (C).
NOTE: If the holes at the end of each X-support
pole (E) do not line up, lightly tap the ends with
a hammer until holes line up. (See Figure 1)
Figure 1
2. Attach X-support pole (E) to the backside of the
caster/frame (C) using 3/8" nuts (A). Tighten nuts firmly,
but not completely, in order to retain flexibility. Repeat
process for the other caster/frame (C). (See Figure 2)
E
PAGE 1 OF 3
1-800-295-5510
uline.com
Hammer
C
Caster/Frame x 2
ASSEMBLY
E
A
C
Figure 2
PARTS
D
E
3. Place support poles (D) in U-shape holders on front
side of caster/frame (C). Keep support poles in
place by inserting support pole D-clips (B) in the
holes on the U-shape holder. To insert support pole
D-clips (B), first open the D-clip by pulling down on
the spring, put through the two holes, and then
release the spring. Repeat process for both support
poles (D). (See Figure 3)
D
Figure 3
4. Double check all nuts and bolts used in assembly.
Tighten each securely.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Support Pole x 2
X-Support Pole x 2
B
C
0822 IH-5121