Publicité
Les langues disponibles
Les langues disponibles
User Manual
▪
Operating Temperature (38163): 0°C - 50°C (32°F - 122°F)
▪
Storage Temperature (38163): -20°C - 70°C (-4°F - 158°F)
▪
Humidity (38163): 10 - 75% RH (non-condensing)
▪
Operating Temperature (38063): 0°C - 70°C (32°F - 158°F)
▪
Storage Temperature (38063): -20°C - 70°C (-4°F - 158°F)
▪
Humidity (38063): 10 - 75% RH (non-condensing)
Connectors
▪
Transmitter Input: HDMI (Female), IR (Female)
▪
Transmitter Output: Duplex LC
▪
Receiver Input: Duplex LC
▪
Receiver Output: HDMI (Female), IR (Female)
Installation
Before starting the installation, please ensure that all devices are powered off.
1. Connect an HDMI source to the Fibre Optic Transmitter device using a HDMI cable (maximum length
5m).
2. Remove the dust covers from the Fibre Optic Transmitter and Receiver ports and the Fibre Cable.
3. Connect one end of the duplex fibre cable to the optical port on the Transmitter and the other end to
the optical port of the Receiver. This must be set up as 1:1 connection and NOT as a cross over
connection as provided by some Duplex Cables with pre-installed clamps on the Duplex connector. If
you have such a cross over cable please exchange the connectors with each other on one end. Please
ensure that the connectors are fully engaged before proceeding.
4. Use another HDMI cable (maximum length 5m) to connect an HDMI display to the HDMI port on the
Receiver.
5. Plug the DC power supplies into the HDMI transmitter and receiver, respectively.
6. Power on the HDMI Source and Display to complete the installation.
As well as extending a HDMI signal the extender can also repeat IR remote commands/signals, with the
use of the optional IR Repeater Kit, allowing you to control your HDMI source whilst up to 3000m away.
Connect the IR Repeater Transmitter and Receiver to the relevant ports on the Fibre Optic Transmitter and
Receiver. Please visit your local Lindy website for more information.
Troubleshooting
There is no display on the screen.
Please note: If both the signal source and display support a higher colour space which require more than
10.2Gbps bandwidth, i.e. YCbCr 4:4:4 8 bit @ 60 Hz, you will receive a blank screen as the HDMI source
will automatically (due to EDID communication) send the higher colour space which exceeds the
bandwidth available of the extender.
In this case you must force the HDMI source to send a lower colour space before you will receive a picture.
▪
Check that the DC plugs and jacks used by external power supplies (both the extender units and
others) are firmly connected.
▪
Check that the Fibre Connectors are plugged in correctly and that the Link Status LED is lit. If it is not
lit check if your cable uses a cross over configuration and change it to 1:1.
▪
Check that the HDMI source and display are both powered on and active.
▪
Power off all the devices, then power on in this order: first, the transmitter and receiver modules, then
the display and finally the source.
▪
Make sure you have not mixed up the Duplex fibres with each other at one end.
▪
Reduce the length of HDMI cable used.
If you cannot solve the problems please contact LINDY technical support.
English
Publicité
