Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.7
When disconnecting the solar panel, always do so in the reverse order of the connecting
procedure and break the first connection while as far away from the battery as practical.
7.8
A marine (boat) battery must be removed and maintained or charged on shore. To
maintain or charge it onboard requires equipment specially designed for marine use.
8.
FEATURES
4
2
3
9.
ASSEMBLY AND MOUNTING INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using
the solar panel.
1. The included four foot pads can be mounted to the corners
of the solar panel to help increase heat dissipation
(see figure 1).
To mount the solar panel
(in a dry location off the ground):
1. Place the solar panel face down on a clean
flat surface.
2. Place the four plastic mounting brackets in
the desired location and rotate each one
90°. Tighten the mounting
brackets, using a flat blade
screwdriver
(see figure 2).
3. Turn the solar panel right
side up, and using the
mounting brackets as a
guide, mark and drill four
mounting holes on a secure,
flat surface and mount
the solar panel with the
four stainless steel screws
provided.
NOTE: Do not over tighten the
screws, or you will break the
plastic frame of the solar panel.
1
5
Fig. 1
5
•
•
1. Solar Panel
2. Quick-Disconnect 50 Amp
Battery Clip Cable Assembly
3. Quick-Disconnect 12V
Accessory Plug Cable Assembly
4. Tinned Wire Cable Assembly
5. Charge controller
6. (4) Plastic Mounting Brackets
(not shown)
7. (4) Heat-Dissipating Foot Pads
(not shown)
8. (4) Mounting Screws
(not shown)
Fig. 2
Publicité
Table des Matières
