Led Lenser H7R.2 Mode D'emploi page 5

connected with the corresponding port at the
supplied charging cable in order to charge
the Accumulator-pack. The other side of the
charging cable (micro USB) must be connected
to the micro USB port on the battery box.Only
the supplied Accumulator battery pack can be
charged with the charger.
The last step is to connect the plug into a
socket (Input: 100 V to 240 V / 50 Hz to 60 Hz).
When charging is completed (after maximum 4
to 5 hours), unplug the charger from the socket
and the charging cable (micro-USB) from the
Accumulator-pack. It is, however, no problem
to continue charging the Accumulator-pack
even it is already full.
When you are charging the Accumulator-Pack
of the H7R.2 with the corresponding charger
and charging cable by a USB port (see Section
9) the charging status will be shown by a
glowing LED light. When the battery is still
charging, it will shine red. The light will change
to green when the charging is completed. You
will be unable to use the white LED of H7R.2
while charging.
Instead of connecting the charging cable to the
USB port of the charger, you can also connect
it to a different USB port (5 V / 500 mA) such as
a computer.
While using our optionally available car USB
charger connection (Led Lenser Car Charger:
Item no. 0380), the H7R.2 also can be charged
at the cigarette lighter and sockets in vehicles.
These accessory units match themselves
automatically to the respective input voltage
(12 V ó 24 V). These alternatives are suitable to
charge the Accumulator-pack in case a power
outlet is not available.
Note – Please ensure that there is no short-
circuit at the charging contacts. The charging
contacts may not be touched with moist or
metallic objects.
10. Changing of the Accumulator-Pack / NiMH-
rechargeable batteries / Alkaline batteries
Prior to the changing batteries, please turn off
the H7R.2.
On the back of the battery box, where the
headband is attatched, there is the gate to the
inside of the battery box. Once you open the
battery box, there will be a silk tab that runs
underneth the battery pack. In order to remove
the battery, pull the silk tab and then insert a
new one.
Alkaline batteries can also be inserted, but
then the charger cannot be used!
During insertion, it is always necessary that
it is in the correct direction. Therefore, pay
attention to the polarities (+ and -). Both in the
battery box and also on the Accumulator-Pack
/ alkaline batteries. Otherwise, there is risk
for damaged Accumulators / batteries and a
possible explosion.
The supplied Accumulator-Pack can only be
recharged with the original charger or by a
USB port (see Section 9)!
After replacing the batteries, the cover of the
battery box has to be closed again.
To close the battery box, hold the battery box
cover over the battery box in the right direction,
hook the battery cover above the multi-function
switch and then push the battery cover against
battery box, until you hear a small "click"
sound. Then push the middle of the cover
again, until you hear another "click". Now the
battery cover is securely closed.
11. Headband
The headband can be washed by water. The
headband can be washed in a washing machine
at 30 °C.
12. Cleaning
To clean, use a dry, lint-free, clean cloth.
If salt water is spilled on the head lamp, it must
be immediately entirely removed with such a
cloth and water.
13. Scope of delivery
The H7R.2 headlamp is supplied with the
following accessories:
1 H7R.2 headband
1 charger and plug
1 USB cable, connect the rechargeable battery
and charger for charge
1 battery pack
1 user manual
14. General information batteries /
accumulators
Non rechargeable batteries or other
accumulators that are not of the same type
of accumulator as the one included in with
this product and therefore not allowed to be
charged by the same charger. Never use non
rechargeable batteries and accumulators
together. Always change all nonrechargeable
batteries and accumulators at the same time.
Only use the Accumulator-Pack (scope of
delivery), alkaline batteries AAA / LR03 / Micro
(1.5 V DC) or NiMH-Accumulator AAA / LR03 /
Micro (1.2 V DC) for the H7R.2.
If you intend not to use the item for an extended
period, please take out the Accumulator-Pack,
NiMH-Accumulators or alkaline batteries in
order to avoid damage.
Used batteries and accumulators have to
be taken out the item and disposed of in
accordance with the national laws. The
possibility of short-circuits of accumulators
and batteries must be eliminated and so they
may not be opened, thrown into a fire, or enter
into the human body in any way.
Do not swallow any small parts or batteries/
accumulators that are present. The products
or parts thereof (including batteries /
accumulators) must be stored out of the reach
of children.
For safety and approval reasons (CE), the
product must not be modified and/or changed.
The product is to be used exclusively as an
accumulator or battery powered lamp. If
the H7R.2 is used for any other purpose, or
incorrectly, it can get damaged and a hazard-
free use is no longer guaranteed (danger from
fire, short-circuit, electric shock etc.) and
therefore there will be no liability for harm
anyone or damage to property. The warranty
of the manufacturer is also rendered null and
void.
GB
04