whisker Litter-Robot 3 Manuel D'instructions page 8

Setting Up Your Litter-Robot
Your Litter-Robot comes fully assembled and ready to use. Get started by following the
steps below.
Placement
‰
If possible, place the Litter-Robot in the same location as the old litter box (at
least during transition).
‰
Make sure the unit is on a firm, level surface. Avoid soft, uneven, or unstable
flooring.
‰
Keep the unit indoors in a cool, dry location. Reduce exposure to high
temperature and humidity.
‰
Locate the unit near a power outlet. Ensure the unit isn't pushed against a wall
or into a corner (must not be touching any walls).
‰ Place litter mats or rugs in front of, or completely under, the unit. Do not place
mats partially under the unit. Use only low pile (6mm) rugs and mats.
Litter
Fill the Globe through the opening with clumping litter until it meets the raised Fill Line
when spread flat (about 3.6-4.5 kg by weight or 6.6 liters by volume). Be careful not to
overfill the Globe.
Fill litter to raised Fill Line
on black rubber liner.
8
whiskersupport.com