Power Supply; Important Instructions - MALONE DX Serie Manuel D'instructions

EN
18
2. Bridge operation
Set the mode switch (3) to 'Bridged'. As already described, the output power
is doubled. Connect the audio cable to input 1 and the output signal can
now be adjusted with the volume control of channel 1. Connect the speakers
to the positive (+) outputs of both outputs and not to the (-) output or
ground. The negative outputs must NOT be used in bridge mode.

POWER SUPPLY

Before connecting the amplifier to the power supply, make sure that the
voltage of the power supply corresponds to the supply voltage of the
amplifier. First connect the IEC end to the appliance and then the power
cord.

Important instructions

• Make sure that all cables are connected correctly!
• Check whether the speakers are suitable for this amplifier!
• Never cover the ventilation grids!
• Protect from rain and moisture!
• Do not plug in or unplug speaker cables during operation!