Device Overview - MALONE DX Serie Manuel D'instructions

EN
16

DEVICE OVERVIEW

1 6.3 mm jack inputs: Two 6.3 mm jack sockets for connecting a signal
source (mixer, etc.).RCA
2 Inputs: Two RCA input sockets for connecting a signal source (mixer
etc.)
3 Mode switch: The amplifier can operate in 2 modes: Stereo and
Pressed. Select one of these modes: Stereo mode: Standard left/
right stereo mode. Bridge mode: This mode of operation combines
both channels on one channel, resulting in doubling the power of that
channel. Connect the signal to the left input channel and the output
level can now be adjusted with the left volume control.
4 Ground Lift Switch: Disconnects the circuits from the ground in case of
problems with ground loops.
5 6.3 mm output: In stereo mode, the load impedance is 4 ohms per
channel.
6 NL4 output: In stereo mode, the load impedance of each channel is 4
ohms. Pin +1 & +2 = + output, Pin -1 & -2 = - output
7 Screw connections Loudspeaker outputs: 4 Ohm per channel. In
bridge mode 8 Ohm.
8 Mains input: First plug the IEC plug into the socket on the appliance
and then plug the other end into a power socket
9 Fuse holder: The fuse protects the amplifier and the connecting wires
against defects. Replace only with a completely identical fuse.