Output Connection; Line-Up - MALONE DX Serie Manuel D'instructions

OUTPUT CONNECTION

The amplifier must be switched off while making the connections. The
speakers can be connected via the NL4 sockets or via wires to the screw
terminals. In the table below, select the appropriate wire gauge that
corresponds to the distance between the amplifier and the speaker.
Distance
< 10 m
> 10 m < 20 m
> 20 m < 30 m

LINE-UP

The amplifier can be set to 2 operating modes:
1. Stereo connection
Set the mode switch (3) to stereo. In this mode, the amplifier has two
independent channels, each with its own input and volume controls.
Strength
1.5 mm²
2.5 mm²
4.0 mm²
EN
17