Frame Assembly - Craftsman CMXGZBF7124586 Guide D'utilisation

917 ASSembLy
Step 4A: (fig. 4A)
If your tractor looks like figure 4A
1. Install two 3/8" x 1-1/4" hex bolts (C) in the left side of
the tractor as shown. Attach the Left Mounting Bracket
(pin at top facing in) to the bolts using two 3/8" lock
washers (L) and 3/8" hex nuts (K). Repeat on the right
side.
Fig. 4A
3/8" LOCK WASHER
3/8" HEX NUT
Step 4b: (fig. 4b)
If your tractor looks like figure 4B
1. Remove the nuts from the two bolt shown in each side
of the tractor, leaving the bolts in place.
2. Attach the Left Mounting Bracket (pin at top facing
in) to the bolts using the original nuts and a 3/8" flat
washer (M). Repeat for the other side.
NOTE: If no bolt and nut are present in a hole, use a 3/8" x
1-1/4" hex bolt (C), 3/8" lock washer (L) and 3/8" hex nut (K)
to attach the Mounting Bracket to the hole.
Fig. 4B
REMOVE NUTS
FROM BOLTS
3/8" x 1-1/4"
HEX BOLT
RIGHT MOUNTING BRACKET
LEFT MOUNTING BRACKET
(L)
(K)
RIGHT MOUNTING
BRACKET
3/8" FLAT WASHER
(TOP HOLE ONLY)
(M)
LEFT MOUNTING
BRACKET
3/8" LOCK WASHER
(If new bolt and nut are needed)
(L)
ORIGINAL NUT
Step 5: (fig. 5)
1. Hook the Sleeve Hitch Frame assembly onto the weld
pins. Attached the bottom of the assembly to the tractor
hitch using a 5/8" x 1-3/4" hex bolt (B) and a 5/8" nylock
nut (H).
NOTE: If your tractor hitch has ridges that prevent the
SLEEVE HITCH
sleeve hitch assembly from resting flat, place the spacer

FRAME ASSEMBLY

plate (O) underneath the sleeve hitch assembly.
Fig. 5
WELD
PIN
Step 6
1. Proceed to LIFT ASSEMBLY instructions on page 4.
EnglIsh
LIFT LEVER
ASSEMBLY
HEX BOLT
5/8" x 1-3/4"
(B)
SPACER PLATE
(SEE NOTE)
(O)
5/8" NYLOCK NUT
(H)
3