Olsson and Brothers MARATHON Guide De L'utilisateur Et Garantie page 22

INDICATIONS FOR THE HANDLING OF THE E-SCOOTER
Check the pressure of the wheels before using it, it is very important to maintain the
proper pressure of the 2 tires, to prolong their life. The optimal pressure of the tires
should be 3 bars.
In case of a puncture, it is recommended to replace the wheel chamber with a
specialist.
1. Turn on the scooter and check the battery level.
2. Place one foot on the scooter's platform, the other must be behind.
3. To make the scooter move, with your foot, push it on the ground and then place it
behind the front foot.
4. Only when both feet rest on the platform of the scooter can you press the
accelerator. Be careful not to accelerate sharply.
5. To reduce the speed, you must press the accelerator in the opposite direction,
or brake with the brake lever. This e-scooter incorporates a double braking system,
electric and brake disc, which act together through the brake handle located on the
handlebar.
6. The E-scooter incorporates the regenerative E-ABS system, not blocking the front
wheel when braking to avoid skidding, as well as an energy system that helps reduce
battery consumption.
7. For emergency braking, you must press the brake handle, which is on the left side.
ADJUSTING A BRAKE DISC
If the brake handle is too tight: Use a hexagonal wrench and slide the screws
counterclockwise of the brake disc tension pulley, shorten the length of the brake cable
a bit and tighten the tension pulley.
If you think that the brake handle has a lot of looseness: Loosen the tensioner pulley,
pull the brake cable to slightly increase a length of its tail. Tighten a tensioning pulley.
ADJUSTING THE BRAKE FORCE OF THE REAR BRAKE
To make a rear disc brake adjustment and braking more effective, the following steps
should be followed:
1. Turning the adjustment 1
brings the pice 3 closer or closer
to the disc.