Electrical Precautions And Shock Hazards - Watts TRITON Guide De L'utilisateur & Manuel D'instructions

Important Safety Information

Electrical Precautions and Shock Hazards

DANGER
!
TRITON is electrically-powered equipment . You MUST follow all precautions necessary for
working with and around electricity and electrical equipment or risk death or serious personal
injury .
• Only plug (connect) the equipment into a
properly-grounded electrical outlet (recep-
tacle) . Make certain that plug matches the
electrical outlet (receptacle) . Never modify
the plug or electrical outlet (receptacle) in
any way .
• Do not use any adaptor plugs or con-
nections . If a properly-grounded electrical
outlet (receptacle) is not available, do not
use this equipment .
• Test the GFCI plug and confirm it is work-
ing BEFORE using the equipment . Do not
use the equipment if the GFCI plug is not
working .
• Do not use the equipment if the Power or
Fuser Cord is frayed, cut, or damaged in
any way . Replace with a new Watts sup-
plied cord before using the equipment .
• Keep the Power and Fuser Cords away
from sharp or abrasive surfaces, moving
machine parts, and heat sources .
• Do not substitute cords from other
manufacturers . Only use TRITON Power
Cords and Fuser Cords with the system .
Substituting alternative equipment may
cause personal injury or damage to the
equipment, or void the product warranty .
• Never use the Power or Fuser Cord to
pull, lift, or move the equipment . Pulling
on the cords can break or damage them,
increasing the risk of electric shock or
electrocution .
8
• Keep the Power and Fuser Cord free of
tangles, twists, knots, or kinks .
• Only use an extension cord or power strip
rated for outdoor use .
• Do not immerse equipment in water or liq-
uids . Do not place equipment in standing
water or liquid during use . These actions
increase the risk of electrical shock and
equipment failure .
• Do not use the equipment during electri-
cal storms . Turn off and unplug (discon-
nect) the equipment from the electrical
outlet (receptacle) and store the unit
indoors if lightening is forecast .
• Turn off and unplug (disconnect) the
equipment BEFORE cleaning, servicing,
or repair . Never attempt to clean, service,
or repair the equipment unless it is com-
pletely off and unplugged .
• Do not attempt to open the Control Unit
or Fuser case (housing) . There are no
serviceable parts inside the Control Unit
or Fuser .