Publicité
Les langues disponibles
Les langues disponibles
6.3
Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
6.4
Fitting the saw blade
1. Remove the battery.
2. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
3. Grip and pull the saw blade to check that it is held securely.
6.5
Fitting the guard
1. Remove the battery.
2. Push the guard onto the power tool from the front until it clicks into place.
The guard can be fitted only when the base plate is in the normal position (zero degrees position).
6.6
Fitting the dust removal adapter
1. Push the dust removal adapter on to the base plate horizontally from the rear until both catches engage
at the side.
2. Connect the vacuum cleaner hose to the dust removal adapter.
7
Operation
Observe the safety instructions and warnings in this documentation and on the product.
7.1
Using a dust extractor
The dust extractor reduces dust emissions, increases working safety by providing better visibility of
the cutting line and reduces exposure to dust and wood chips at the workplace.
1. Fit the guard. → page 22
2. Always use a dust extractor when working over a lengthy period with wood or materials that can cause
high dust concentrations.
7.2
Switching on
6
1. Insert the battery.
A safety interlock ensures that the tool doesn't start when the tool is first switched on and the
battery then fitted, i.e. slid into place on the tool.
2. Check that the lockbutton is in the middle position.
3. Press the on/off switch.
4. To lock the switch in the "on" position, then push the lockbutton to the right.
5. To release the lockbutton, press the on/off switch again.
▶ The lockbutton then returns to the middle position.
7.3
Plunge cutting
1. Set the orbital-action adjusting lever to position 0.
2. Bring the front edge of the base plate into contact with the workpiece.
3. Hold the product securely and press the on/off switch.
4. Press the product firmly against the workpiece and begin the plunge cut by slowly reducing the angle of
attack.
5. Once the blade has penetrated right through the workpiece, bring the product into its normal working
position.
▶ The base plate then lies flat on the working surface.
6. Continue to saw along the cutting line.
22
English
3
4
5
2149486
*2149486*
Publicité
