Hilti SJD 6-A22 Mode D'emploi Original page 25

▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series to charge these batteries.
▶ Use this product only with saw blades equipped with a T-shank.
3.3 Possible misuse
• Use of the product to cut off tree branches or to cut the trunk of a tree is not permissible.
• Use of the product to cut hazardous materials is not permissible.
• Use of the product in a damp or wet environment is not permissible.
▶ Keep objects such as paper clips, coins, keys, nails, screws, or other small metal objects, which could
cause a short circuit, away from the electric power supply for the dust removal module. A short circuit
between the contacts may result in burning injuries or fire.
3.4 State of charge display
The charge state of the Li­ion battery is displayed after pressing one of the release buttons lightly (press only
until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery charge state LEDs blink, please refer to the information
given in the Troubleshooting section.
3.5 Dust blower
The dust blower directs a jet of air toward the saw blade in order to keep the cutting line free of dust.
3.6 Stroke rate
The stroke rate can be adjusted by turning the thumbwheel. Position 1 corresponds to 800 strokes per
minute and position 6 corresponds to 3000 strokes per minute.
Depending on how far the on/off switch is pressed, the stroke rate begins at 75 strokes per minute and
increases to the stroke rate set by the thumbwheel.
3.7 4 orbital-action settings
The 4 orbital-action settings allow cutting performance and quality of cut to be adjusted to suit the material
to be cut. The orbital-action adjustment lever is used to set the power tool to one of the 4 settings.
The lower the orbital-action setting, the finer and cleaner the cut edges will be. The optimum setting can be
determined by carrying out practical tests.
Status
Position 0
Position 1
Position 2
Position 3
3.8 Lockbutton 2
The lockbutton has three positions.
• The middle position is the normal position: The lockbutton can be seen on the left and on the right. In
this position, for example, the stroke rate can be adjusted.
The on/off switch can be pressed and released.
*2149486*
Meaning
Charge state: 75 % to 100 %
Charge state: 50 % to 75 %
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
Charge state: < 10 %
Meaning
No orbital action
Low orbital action
Medium orbital action
High orbital action
2149486 English 19