Grinder Operation; Cleaning And Maintenance - Black & Decker BX4000 Mode D'emploi

Grinder operation

• Place the motor unit (5) on a flat horizontal surface and
make sure it is unplugged.
• Fill the grinding bowl (9) with coffee beans, and then put
the grinding blade assembly (8) onto the grinding bowl
bottom and rotate it anticlockwise to fix it onto the
grinding bowl (9).
Note: The maximum quantity of coffee beans the grinding
bowl allows to grind is 50g.
• Assemble the grinder attachment (8) onto the motor unit.
Note: There is a safety interlock device at the bottom of
motor unit, if the grinder is not assembled in place, the
grinder will not operate.
• Make sure that the Control Knob (6) is set to the "O"
position before operation, then connect the appliance to
the power outlet.
• Select the desired speed setting on the Control Knob
(6), the appliance will start to grind. During grinding, you
can turn the Control Knob (6) to "Pulse" position without
releasing it if you want to accelerate the process of
grinding.
• Disconnect from the power supply once finished. And
then disassemble the grinder attachment from the unit,
keep the grinding bowl downward and turn it
anticlockwise, then empty the bowl and serve.
Note: Do not run the appliance for more than 30 second per
time, and wait until the unit is cooled to room temperature
before performing next operation cycle.

Cleaning and Maintenance

Before performing any maintenance:
• Switch off and disconnect from the mains supply.
• Wait for the appliance to completely cool down.
Warning! Do not immerse the appliance, the base, the cord
set or the plug in water or any other liquid.
• Wipe the exterior with a damp cloth.
• Do not use scouring pads.
• If necessary, use a mild detergent to remove spots.
• Do not use any abrasive or solvent based cleaner.
• Do not immerse the power base in water or any other
liquid.
For blender attachment:
The Auto Clean function can clean the blender easily and
rapidly in complete safety.
• Pour a little warm soapy water into the jar (3) and turn
(Original instructions)
the Control Knob (6) to "1" position and run the appliance
for a few seconds.
• Dissemble the jar from the motor unit and rinse it under
running water, then detach the blending blade assembly
from the jar assembly, detach the measure cup from the
jar cover. Finally, rinse the jar, blending blade assembly,
jar cover and measuring cup under running water.
• Dry all parts and then assemble them.
For grinder attachment:
• Rotate the grinding blade assembly clockwise to detach it
from the grinding bowl, and then rinse the grinding blade
assembly and the grinding bowl under running water.
• Dry all parts and then assemble them.
Mains plug replacement
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the new
plug.
• Connect the blue lead to the neutral terminal.
• If the product is class I (earthed), connect the
green/yellow lead to the earth terminal
Note! If your product is class II double insulated (only 2 wires
in the cord set), no connection is to be made to the earth
terminal.
Follow the fitting instructions supplied with good quality plugs.
Any replacement fuse must be of the same rating as the
original fuse supplied with the product.
Warning! The above section on mains plug replacement is
for authorized service centre persons.
ENGLISH
5