SEVERIN SM 9685 Mode D'emploi page 10

5. Place the lid and insert on the
container.
6. Insert the plug into a suitable wall
socket. A beep signal is heard and the
65° C indicator starts fl ashing.
7. Use the temperature selection button to
set the desired temperature or the cold-
frothing function (blue dot symbol).
Th en press the On/Off switch.
Aft er a beep signal is heard, the indicator
light for the selected temperature
function shows a steady light and the
cooling system of the motor is heard to
start up.
A moment later, the appliance starts
to stir the milk. Once the milk is
suffi ciently hot or the cold-frothing
process is complete, both heating and
stirring processes stop automatically.
Th e indicator light for the selected
temperature function fl ashes, and a
number of beep signals are heard.
8. You can now remove the milk container
from the base. Use a suitable spoon to
take off the milk froth.
Th e cooling system continues to run for
a brief period.
Th e temperature indicator lamp stops
fl ashing aft er about three minutes.
Remarks
If the appliance has not been disconnected
from the mains , the On/Off switch must be
pressed twice to start a new operating cycle.
Aft er a heating cycle, the appliance cannot
start a new stirring and heating cycle
immediately, but must be allowed to cool
down fi rst.
Aft er a cold-frothing cycle, a new stirring and
heating cycle may be started immediately.
Making cocoa
Th e appliance is also suitable for preparing
cocoa drinks. Proceed as described in the
section Heating up or frothing milk. Fit the
smooth stirring head and set the temperature
selector to 60° C. As soon as the milk has
been heated to 60° C (as indicated by the
corresponding beep signals), take off the lid
insert and add the required amount of cocoa
powder. Now set the temperature selector to
65° C and press the On/Off switch again.
To prevent any blockage or congestion, do
not use grated chocolate or chocolate fl akes
when making cocoa.
Interrupting or ending a cycle
Press the On/Off switch to stop the heating
and stirring process: Th e main indicator
lamp starts fl ashing and the motor cooling
system can be heard.
To continue the heating and stirring process,
Press the On/Off switch again.
Switching the appliance off
Remove the plug from the wall outlet to turn
the appliance off completely.
Hint
To achieve a thicker froth, go through a
cold-frothing cycle fi rst, followed by a hot-
frothing cycle.
General Care and Cleaning
Always remove the plug from the wall
socket and wait until the motor has come
to a complete standstill before cleaning
the appliance.
To avoid the risk of electric shock, do not
clean the base or the power cord with
water and do not immerse them.
Th e container, stirring heads and lid may
be cleaned with hot water and a little
detergent. Th e attachment parts are also
dishwasher-safe.
– Wipe all parts thoroughly dry.
– Th e base may be cleaned with a damp
cloth and a little detergent.
Do not use abrasives or harsh cleaning
solutions.
10