Surface Burners - Haier QCGSS740RNSS Guide Rapide

IMPORTANT SAFETY INFORMATION
WARNING
OVEN SAFETY INSTRUCTIONS
WARNING
NEVER cover any slots, holes,
or passages in the oven bottom or cover an
entire rack with materials such as aluminum
foil or oven liners. Doing so blocks air flow
through the oven and may cause carbon
monoxide poisoning. Never place foil or oven
liners on the oven bottom. They can trap heat
causing risk of smoke or fire.
• Stand away from the range when opening the oven
door. Hot air or steam which escapes can cause burns
to hands, face and/or eyes.
READ AND SAVE THESE INSTRUCTIONS
USING YOUR NEW APPLIANCE
NOTE: Remove all protective packing before operating
the oven.
The full owner's manual for your product includes
additional information and cooking guides. Access the
manual by searching for your appliance model number at
Haierappliances.com.

SURFACE BURNERS

How to Light a Surface Burner
WARNING
Burners should be operated only when
covered by cookware. Burner flames not covered by
cookware present a risk of fire or clothing ignition. Never let
flames extend beyond the sides of the cookware. Failure to
comply may result in serious injury.
Make sure all burners are in their correct locations and fully
assembled before attempting to operate any burner.
Select a burner and find its control knob. Push the knob in
and turn it to the LITE position.
4
• Never place cooking utensils, pizza or baking stones, or
any type of foil or liner on the oven floor. These items can
trap heat or melt, resulting in damage to the product and
risk of shock, smoke or fire.
• Place oven racks in desired location while oven is cool.
If rack must be moved while oven is hot, be careful to
avoid touching hot surfaces.
• Do not leave items such as paper, cooking utensils, or
food in the oven when not in use. Items stored in an
oven can ignite.
• Do not leave items on the cooktop near the oven vent.
Items may overheat resulting in a risk of fire or burns.
• Never broil with door open. Open-door broiling is not
permitted due to overheating of control knobs.
In Case of a Power Failure
In the event of a power failure, the oven is inoperable and no
attempt should be made to operate it. However, the surface
burners may be lit with a match. Using extreme caution,
hold a lit match near the ports beneath the surface burner
cap, then slowly turn the knob to the LITE position. Once lit,
surface burners will continue to operate normally.
You will hear a clicking noise—
the sound of the electric spark
igniting the burner. When one
burner is turned to LITE, all
burners will spark. Sparking will
continue as long as the knob
remains at LITE. Once gas is
ignited, turn the knob to adjust
the flame size.
Push the control knob in and
turn it to the LITE position.
295D1344P039 / 29-6359 Rev 0